Rectangle Double Stitch Nesting Metal Cutting Dies – Set of 6

Create clean, professional layered frames with this rectangle double stitch nesting die set. Featuring stitched detailing both inside and outside the cut line, these dies add subtle texture and definition to card fronts and scrapbook layouts.

Key Features

• Nesting set of 6 rectangular metal cutting dies
• Largest die approximately 11 cm x 9 cm (4.33 x 3.54 inches)
• Smallest die approximately 5 cm x 3 cm (1.97 x 1.18 inches)
• Double stitch detailing – stitch line on both inner and outer edges of the cut
• Evenly spaced sizing ideal for layering
• Made from durable carbon steel
• Compatible with most manual and electronic die-cutting machines
• Suitable for paper, card and similar craft materials

Sizing Guidance

With the largest die measuring 11 x 9 cm, this set creates strong layering panels for A6 and 5x7 cards.

Smaller sizes are ideal for sentiment mats, photo framing and stacked dimensional layers. The smallest rectangle works well as a focal panel or topper element.

Ideal Card Sizes

• A6 – layered stitched panels
• 5x7 – full decorative focal frame
• 6x6 – central stitched feature

Perfect For

• Layered card fronts
• Framing stamped sentiments
• Scrapbook photo mats
• Shaker card frames
• Clean and modern card designs
• Decorative background panels

Description

This double stitch rectangle nesting die set offers classic framing with added detail. Each die creates a clean rectangle cut while embossing stitched detailing both inside and outside the cut line, giving a refined, tailored finish to every layer. The balanced spacing between sizes makes stacking simple and visually consistent. Whether you prefer minimalist layouts or multi-layered dimensional designs, this set provides crisp cuts and subtle texture that enhances without overwhelming your project.

Please Note

Die set only is included. Photos may show example cuts to demonstrate the design the die creates.

This nesting set is supplied connected and is intended to be separated before first use.

For best results, first gently twist the individual dies away from each other to separate the main frame. Once separated, any remaining connector tabs can usually be detached by gently wriggling and twisting them using small pliers or nippers. Depending on the set, some tabs may require careful trimming with fine snips if they do not release easily.

Measurements are approximate and taken from the outer cutting edge. Finished cuts will be slightly smaller.