Nest of 12 Square Circle-Hole Edged Metal Cutting Dies – Layering & Frames

• Set of 12 nested square dies with decorative circle-hole edging
• Supplied connected — can be separated before use
• Largest die approximately 13.8 cm × 13.8 cm (5.43 × 5.43 inches)
• Smallest die approximately 2.7 cm × 2.7 cm (1.06 × 1.06 inches)
• Approximate 1 cm (0.39 inch) size reduction per step
• Creates panels, frames and apertures for layered designs
• Durable carbon steel — precise, reusable and long-lasting
• Compatible with most manual & electronic die-cutting machines
• Suitable for cutting paper, card and speciality materials

Ideal Card Sizes

• Perfect for 6 x 6 inch card bases
• Suitable for 5 x 7 inch cards
• Works well for layered A6 (105 x 148 mm) designs
• Ideal for square layered scrapbook layouts

Perfect For

• Layered greeting cards
• Framed sentiments
• Scrapbook layouts
• Journal pages
• Aperture cards
• Decorative panels and mats

Description

Create detailed layered designs and decorative frames with this Nest of 12 Square Circle-Hole Edged metal cutting dies set. Featuring a decorative pierced circle-hole border on each die, this set is perfect for adding texture and dimension to your paper craft projects.

The nesting design allows you to cut coordinating layers, frames, apertures and mats with evenly spaced sizing steps.

Made from durable carbon steel, these dies provide clean, precise cuts and are compatible with most manual and electronic die-cutting machines.

Please Note

Die set only is included. Photos may show example cuts to demonstrate the design the die creates.

This nesting set is supplied connected and is intended to be separated before first use.

For best results, first gently twist the individual dies away from each other to separate the main frame. Once separated, any remaining connector tabs can usually be detached by gently wriggling and twisting them using small pliers or nippers. Depending on the set, some tabs may require careful trimming with fine snips if they do not release easily.

Measurements are approximate and taken from the outer cutting edge. Finished cuts will be slightly smaller.